• Advertisement

RM380

Moderators: Scorpion8, ripjack13, John A.


Copper BB
Posts: 9
Joined: Tue Oct 09, 2018 10:22 am
PostPosted: Fri Oct 19, 2018 6:30 pm
Had to send my RM380 back to Remington straight out of box from my trigger would not pull the hammer back upon looking at sear the nub needs a flange to hold trigger bar in place.

Copper BB
Posts: 2
Joined: Mon Aug 06, 2018 10:17 pm
PostPosted: Sat Oct 20, 2018 2:12 pm
I sent mine back last week. The trigger slips every second pull. Very unhappy that a brand new gun needs repair. At least it's under warranty.

20g
Posts: 609
Joined: Sat Oct 26, 2013 4:00 pm
PostPosted: Mon Oct 22, 2018 5:49 pm
I would be pissed too. What is so hard to get straight? Is it Q.C. or manufacturing issue. Like the looks of that .380 just don't understand. Glad I bought my S&W CS-9 years back. Goes bang everytime at least.

Copper BB
Posts: 2
Joined: Mon Aug 06, 2018 10:17 pm
PostPosted: Tue Oct 30, 2018 4:38 pm
I just got an email saying my RM380 will be back this Thursday, but no explanation of what the problem was. I'll have to wait to read the report.

20g
Posts: 609
Joined: Sat Oct 26, 2013 4:00 pm
PostPosted: Wed Oct 31, 2018 9:47 am
Hope this time it functions OK. Had high hopes for this metal gun.

Copper BB
Posts: 9
Joined: Tue Oct 09, 2018 10:22 am
PostPosted: Fri Nov 02, 2018 12:18 pm
I am getting RM380 back monday email said they adjusted trigger bar and new spring then test fired.

20g
Posts: 609
Joined: Sat Oct 26, 2013 4:00 pm
PostPosted: Fri Nov 02, 2018 7:24 pm
Hope they got it right this time. Bet they did not have all these failures years back before coming out with these newer budget or less expensive to make firearms. Ruger sent me a new mag for my 22 mag American as the original one had sticky feeding. Seems the spring did not have enough tension.

Copper BB
Posts: 9
Joined: Tue Oct 09, 2018 10:22 am
PostPosted: Wed Nov 07, 2018 10:54 pm
Got it back Monday late in evening seems to be ok will take to range tomorrow.

Return to Remington RM-380

Who is online

Users browsing this forum: No registered users and 0 guests

  • Advertisement